Staff Answer
May 27, 2026 - 06:39 AM
Yes — the MORryde CRE3000 CRE2-35 should work with your setup provided your current equalizer measurements match the CRE2-35 dimensions.
Key fitment points for the CRE2-35:
- Designed for 35" axle/wheelbase spacing
- Fits standard trailer leaf springs, including 2-1/4" wide springs
- The important measurement is the equalizer bolt-hole spacing, not just wheelbase
For the CRE2-35, the lower bolt holes should measure approximately:
- 7-3/4" center-to-center horizontally
You mentioned your spring eye spacing is about 7-1/2". That is close enough that this kit will usually fit fine, especially since many OEM equalizers vary slightly from nominal dimensions.
Before ordering, I’d still recommend confirming these two measurements on your current equalizer:
- Horizontal bolt spacing (center hole to center hole across bottom)
- Equalizer height (top bolt hole to bottom bolt hole center)


Add New Comment